Owner`s manual

Page 6 Owner’s Manual MST660
INSTALLATION
Location
The MST660 is designed to be mounted in several different ways to enable it
to be installed in the most convenient position. Although the unit is water
resistant when the front cover is closed, care should be taken to locate it
where it will not be subjected to spray or rain. The unit should be mounted
with an angle of less than 20° to the horizontal plane (see diagram) and in a
position that is free from direct sunlight and excessive vibration.
Upright or Overhead Mounting
1. Attach the two gimbal knobs and the self-adhesive rubber washers to the
MST660 and slide the unit into the mounting bracket. Ensure the rubber
washers are between the bracket and the CD player’s case. Tighten the
knobs firmly.
2. Temporarily position the MST660 in the desired location and roughly mark
the location of the bracket edges. Now, remove the unit from the bracket
and reposition the bracket to mark the mounting hole positions. A range of
mounting holes is provided to suit most installations.
3. Screw or bolt the bracket into position. The mounting method will depend
on the material to which the bracket is being attached.
4. Slide the MST660 back into the bracket slots and adjust for the correct
position before tightening the gimbal knobs. Remember to avoid
exceeding the maximum mounting angle of 20°.
5. Complete the antenna lead and electrical wiring as described later.
20˚
20˚
20˚
20˚
Flush Mount
Overhead Mount
Upright Mount
✔
✔
✔
✘
MST660 I.M.-2 21/12/99 1:26 PM Page 8