Owner`s manual

TROUBLE SHOOTING
The following checks will assist you in solving most of the problems you are
likely to encounter after installing your MST660. Should any problem persist
after you have tried these ideas, consult your dealer for advice.
ERROR CODES
The MST660 is controlled by an advanced microprocessor. If a problem
occurs with the unit’s normal operation, the microprocessor will sense this and
display an error code. If the error codes E1, E2 or E3 appear on the display at
any time, remove the front panel and press the Reset button. In most
instances, this will fix the problem. If the error persists, return your MST660 to
your dealer for repair.
MST660 Owner’s Manual Page 19
CAUSE
The vessels battery switch is
not on.
One of the fuses has blown.
There is already a disc in the
player.
You are trying to insert the CD
upside down.
The CD is very dirty or
defective.
The temperature is too high -
the sun has been shining
directly onto the unit.
There is condensation on the
laser lens.
SYMPTOM
No Power.
Disc cannot be loaded or
ejected.
SOLUTION
If the power supply is
connected to the vessels
battery via a master switch,
turn the master switch on.
Replace the damaged fuse.
Remove the disc in the player,
then insert the new disc.
Insert the CD with the label
facing up.
Clean the CD or try another
CD.
Cool the unit down or protect
it from direct sunlight.
Leave the player off for an
hour or so, then try again.
MST660 I.M.-2 21/12/99 1:26 PM Page 21