Owner`s manual

Page 8 Owner’s Manual MST660

4. If your measurements are correct, carefully cut the slot around the marked

lines, ensuring that you maintain the curves in each corner. Mark and drill

the four 0.08'' holes in the bulkhead to accept the locating pins at each

corner of the escutcheon.

5. Trial fit the escutcheon to ensure it fits securely against the panel. If all is

well, place a small dab of glue on each locating pin and press the

escutcheon into place. Temporarily hold with tape if necessary.

6. With the escutcheon firmly glued in place, slide the MST660 through the

slot from the front and push it all the way in, while leaving a clearance for

the front cover to hang in the open position. Open the cover if necessary

to ensure the correct clearance.

7. Holding everything in position, mark the location of the internal support

bracket(s). Drill the required holes and fit the bracket(s) as required to hold

the MST660 firmly in place.

Note: If using the perforated metal support strip, mount it to the rear of the

MST660 as shown in the diagram below.

8. Complete the antenna lead, speaker and power wiring as described later.

ELECTRICAL WIRING

DC Connections

Caution: The MST660 is designed for vessels with a 12 Volt negative ground

electrical system only!

Perforated Strip

Escutcheon

Mounting Bracket

Bolt

Washers

MST660 I.M.-2 21/12/99 1:26 PM Page 10