User guide

User interface Main UI 69
• Current version: Release code of currently installed firmware.
Figure 55: MENU>SYSTEM>FIRMWARE
12.1.5.5 User Setups
In this section the user can store the current setup to the SD card or
load previously stored setups from the SD card. An SD card must be
present in the camera to perform these operations. Only complete
camera setups can be stored or loaded!
Note: It is recommended to create a default starting setup to load into any new
camera you work with. This way you can ensure all parameters meet your
expectations.
• Save current setup: A setup containing the current camera
settings is stored to the SD card. File is named with time and date
stamp.
• Load setup: Loads a list with all setups located on the SD card.
Select a setup and load it.
Note: Before loading or saving a setup, make sure an SD card is present. When
saving a setup, the write protection of the SD card must be switched off.
• Factory reset: Resets the camera to factory defaults. Confirm
factory reset by pushing the two lower outer screen buttons
simultaneously when the request appears.
Figure 56: MENU>SETUPS