User guide

User interface Main UI 51
12.1.4.2 FPS
Pressing the FPS screen button opens the Fps user list. It contains the
default framerates 23.976, 24.000, 25.000, 29.970, 30.000, 48.000, 50.000,
59.940 and 60.000 fps.
The user can store a selection of his preferred fps settings for quick
access. To select an fps preset, turn the jogwheel until the selection bar
is on the desired value, then press the jogwheel again.
The screen buttons on the screen bottom are shortcuts to the menu
screens of REC OUT and MON OUT, where the output settings can be
adjusted if they do not match the sensor fps.
Figure 31: List example: User list fps
If the list lacks the required setting, press the ADD screen button. This
opens a screen where the desired setting can be set. Either use the
jogwheel to set the desired value, or additionally use the screen buttons
for bigger adjustment steps. When the desired value is set, press the
jogwheel to add the value to the list.
Note: A maximum of 16 entries is supported by the list. After reaching this
number of entries, it is no longer possible to add entries without deleting others
first.
List values no longer required can be deleted by pressing the DELETE
screen button. This opens a screen where the values desired for
deletion can be selected with the jogwheel. To delete the selected
value, press the two lower outer screen buttons simultaneously.