User guide

46 User interfaceMain UI
USER BITS
The content of the User binary group in the time code. Can contain 8
letters of Hex values (0-9, A-F).
Press the SET UB screen button to adjust the User Bits values.
Figure 25: User bits screen
12.1.3.2 INFO
System Info
The first info page contains information on the current state of the
camera system. If no info is displayed, everything behaves normally.
Messages can either contain a warning or an error message.
When an SD card is present, a system log can be stored to the SD card
by pressing the lower mid screen button labeled SAVE TO SD. Patience
is required as it can take about a minute until the log is written to the
SD card.
Note: Saving a system log is only necessary if the camera is showing unnormal
behaviour. It can then be sent to the ARRI camera service for analysis. The log
is not human-readable and can only be analyzed by the ARRI camera service.