User guide

44 User interfaceMain UI
Operations that cannot be reversed and can result in the loss of data
require the simultaneous pressing of two buttons to prevent them from
accidental use.
12.1.3 Function Buttons
The following function buttons are available on the main UI:
• ON/OFF: Press shortly to switch the camera on. To switch off the
camera, the button must be pressed for several seconds. In the
Homescreen, a countdown is displayed. If the button is released
before the countdown has elapsed, the camera does not shut
down. When a power source is connected to the camera, the
ON/OFF button flashes once per second when the camera is
switched off.
• REC: Currently not in use.
• LOCK: Press long to lock the user interface. When locking the
camera, the UI returns to the Homescreen. Buttons USER, HOME
and ON/OFF are not affected by the lock.
• GRAB: Currently not in use.
• TC: Enters the screen for configuring Time code.
• PLAY: Currently not in use.
• INFO: Enters the Live Info screen, where you get information on
the current state of the system. Also available is version info,
where you get information on camera hard- and firmware.
• USER: Enters the user screen, where you can assign the three
user buttons of the operator UI, as well as the six screen buttons
of the user screen (Note: the top three screen buttons of the user
screen reflect the behaviour of the three user buttons of the
operator UI).
• MENU: Starts the menu, where most camera settings can be
adjusted. Navigate inside the menu with the jogwheel.
• BACK: When navigating, this button brings you back to the
previous page. When editing, this buttons reverts your
adjustment and quits edit mode.
• HOME: Returns to the Homescreen from anywhere in the UI.
12.1.3.1 TC (Time Code)
The TC screen shows the currently set TC. By pressing the OPTIONS
screen button, the time code Options list opens, where TC settings can
be changed.
• Source: Choose the TC source
− Int TC: internal TC counter
− Ext LTC: TC is jam synced from the LTC input. Only possible
with Mode set to Free Run.
− SDI LTC: currently not supported
− SDI VITC: currently not supported
• Mode: Sets how the TC is counted