User guide

Connectors TC 37
10.11 TC
The TC connector is a 5pin LEMO socket. It accepts and distributes LTC
time code signals.
It can be used to
• Jam sync the camera to a Clockit, TC Slate or another camera
• Transmit the camera's time code to Clockit, TC Slate or another
camera
• Tune the camera crystal oscillator's frequency with an Ambient
ACC Clockit Controller
It is located on the camera right lower front.
10.12 3.5mm TRS connector
The 3.5mm TRS connector is currently not in use.
It is located on the camera right lower front.
10.13 SD Card
The SD card slot is located at the bottom on the camera right side
middle. Any SD or SDHC card with a capacity of up to 4 GB can be
used. The card must be pre-formatted with an FAT32 file system. The
slot is protected from dirt and rain by a slider door. Insert the SD card
according to the drawing on the camera housing.
Note: Always keep the slider door closed during operation to prevent dirt and
moisture from entering the camera.
On the SD card, the following folder structure should be created by the
user prior to first use of the card:
• ARRI
ALEXA
Setups
Firmware
Framelines