User guide

26 Installation of The CameraElectronic Viewfinder EVF-1
9.3.1 Viewfinder Cables
The viewfinder cables are unidirectional with a male plug to connect to
the camera and a female plug to connect to the EVF.
Cables are available in the following lengths:
Model Length
(m / ft)
Purpose
KC-150-S 0.35 / 1.2 For use of EVF-1 on camera left side in
handheld mode
KC-151-S 0.65 / 2.1 For use of EVF-1 on camera right side or
when using Viewfinder Extension Bracket
VEB-1
KC-152-S 2.00 / 6.6 Longest possible length for use with
specialty rigs
Figure 9: Evf cables: KC-150S (center), KC-151S (middle), KC-152S
(outer)
9.3.2 Viewfinder Mounting Bracket
The viewfinder mounting bracket VMB-1 is attached to the camera with
two 3mm hex screws at the very front of the camera top. The
viewfinder is attached to the mounting bracket by sliding the swallow
tail into the receptacle of the mounting bracket and then closing the
lever on the viewfinder.
The position of the viewfinder can be adjusted by loosening the levers
of the mounting bracket, adjusting the position as desired and closing
the levers.