Instruction Manual

MU100 Communication Adapter - USB Driver Installation Instructions
1. Go to:
mark-10.com/products/accessories/power-communication/communication-adapters/
2. Under the Downloads section, click MU100 USB Driver (ZIP le).
3. Extract the les, then run the USB Driver installer, “MU100_USB_Driver.exe”. Follow
the instructions on the screens.
4. After the installation completes, connect the MU100 to a USB port on the PC.
5. Windows will assign a COM port number, viewable in Device Manager > Ports.
Mark-10 Corporation n www.mark-10.com n [e-mail]
Toll-free: 888-MARK-TEN
n Tel: [phone] n Fax: [phone]
32-1248
The MU100 communication adapter converts Mitutoyo signals into USB, typically
used for transmitting data from a Mitutoyo travel display on a Mark-10 test stand to
data collection software on a PC. Cable part no. 09-1066 is required between the
Mitutoyo device and MU100.
Follow these instructions to install the USB driver: