User Guide

Model 3i Digital Force/Torque Indicator User’s Guide
6
3.2 Mounting to a plate
The 3i can be mounted to a plate with four thumb screws fastened into the appropriate holes in the rear
half of the housing. Refer to the Dimensions section for detailed hole information and locations.
3.4 Installing the USB driver
If communicating via USB, install the USB driver available at:
www.mark-10.com/resources
Caution!
Install the USB driver before physically connecting the indicator to a PC with the USB cable.
Further instructions for configuring and using the indicator’s outputs are provided in the Communications
and Outputs section.