User Guide

Model 3i Digital Force/Torque Indicator User’s Guide

11.3 LCD Contrast

The contrast of the display may be adjusted. Select LCD Contrast from the menu. The screen appears

as follows:

Press ENTER to modify the contrast. Select a value from 0 to 25, 25 producing the most contrast.

11.4 Tones

Audible tones can be enabled for all key presses and alerts, such as overload, set point value reached,

etc. The Set Point alert can be configured to be either a momentary tone or a continuous tone (until the

load is restored to a value between the set points). To configure the functions for which audible tones will

apply, select Tones from the menu. The screen appears as follows:

11.5 Initial Mode

This section is used to configure the initial mode upon powering on the indicator. To access this

parameter, select Initial Mode from the menu. The screen will display the available modes, which is

determined by whether a force or torque sensor is connected. An example is as follows:

The default value is Real Time.

11.6 Restore Default Settings

Default factory settings can be restored by selecting Restore Defaults from the menu. The settings may

be found in the Specifications section. The screen appears as follows:

INITIAL MODE

* Real Time

Peak Compression

Peak Tension

TONES

Keys

* Alerts

Set Points

* Momentary

Continuous

LCD CONTRAST

Set Contrast