Installation Instructions

//Data2/MarineSync-Sales Marketing/Approved Technical Docs/RUM

When connecting more than one meter to the RUM Transponder, use terminal #8, #10 and #11.

If the utility meter provides more than one output resolutions (10, 100, 1000), determine the

appropriate resolution for your application (fig 2) and connect to the RUM meter input. If you need

assistance selecting a resolution, contact MarineSync.

Figure 2

Decals have been provided (fig 3) to identify the Transponder ID installed at each pedestal. Use the

corresponding “input” decal to label the receptacle or side of the pedestal connected to the

transponder. Place the decal in a visible location and ensure the decal is adhered in a protected location

for future reference.

It is extremely important to properly label the pedestals. The Transponder ID and the meter inputs are

used during setup, troubleshooting and system maintenance.

Figure 3

Output Resolutions

Isolated 10 = 100 Pulses per kWh

Isolated 100 = 10 Pulses per kWh

Isolated 1000 = 1 Pulse per kWh