User manual
MPC-ML10DVR-UM(B) 4/2011 15
There are three mounting holes in the center-back of Display for the ball mounting plate.
Take care not to strip screw holes or over tighten. (Figure 4)
• Note location of three mounting holes on a ball mounting plate (Figure 4)
• With three (3) M4 x 10 counter-sunk stainless screws attach this mounting plate to
back of the MPC-ML10DVR
• Mount second ball mounting plate where Display will be installed
• Insert each ball into RAM arm
• Lightly tighten arm around balls using T-knob on arm (Figure 2, 4)
• Adjust Display to viewing preference, and
• Tighten T-knob to hold Display in position.
It is recommended the remaining ball be mounted on a at surface. Because of various
surface substrates Display will be mounted on, installer will provide screws to mount
other ball.
Take care not to strip screw holes or over tighten as the enclosure is aluminum.
Caution!
Panel Mount
Panel Mount installation should be specied at time of
order; the ball-and-socket mount system will not be
included in the shipping box. (Figure 5)
For installation, there are four tapped mounting holes
on four corners of the Display’s rear panel. Mounting
hardware packet is included with product accessories
in the shipping box. This packet includes four (4) M4
stainless steel threaded studs, 7.6 cm (3” long), four
(4) Nylock self-locking nuts and four (4) at washers.
It is recommended installer refers to mount drawings
on MarinePC’s web site, (www.MarinePC.com), for exact
measurements. These drawings should be helpful
when installer cuts the required opening for the
Panel Mount installation.
Figure 5