User manual

MPC-ML10DVR-UM(B) 4/2011 11
Product has been engineered to meet or exceed international industry stand-
ards addressing product design and enclosure protection against EMI/RFI. For
compliance with specic MIL-STD-461E standards, please consult factory.
EMI/RFI
Caution!
Electrical
Connecting Cables
• Disconnect power to computer when Display is being installed
• Upon installation, verify power input connector is securely seated on Display
• Position power cable so it is not in contact with hot surfaces
• Do not allow anything to rest on power cable, and
• Protect power cable from extreme heat sources.
Power Source
• Always connect to a properly grounded DC (standard) power source
• Any equipment to which Display is attached must also be connected to properly wired
and grounded power sources
• Input voltage is 10 - 36 VDC
MPC-ML10DVR power consumption is listed at 6 watts minimum - 20 Watts maximum.
Power Consumption
Warning!
Protection on Servicing
Servicing - User
• User Servicing is limited to cleaning the Display
• Do not disassemble or modify the Display to avoid the possibility of electrical shock,
damage to its electrical components or scratching the Display surface, and
• Disassembly voids the warranty.
Servicing - Marine PC
Marine PC Qualied Service Personnel may be required to service the Display if:
• Does not operate normally when installation instructions are followed
• Does not operate normally when operating instructions are followed
• Has been dropped or damaged, or
• Exhibits a distinct change in performance, indicating a need for service.
Shipping
If Display should need to be shipped to the MarinePC Service Center, the original packing
material should be used to insure safety of Display in shipping. Repack Display as it
would have originally been received from MarinePC.