User Manual

Hold the back bracket hanger in position against the wall in the desired hanging

location. Check to make sure that the bracket is level. Mark the wall where the

mount-ing holes should be located. Drill holes of ¼" diameter in the marked

locations. If you are on a stud, screw the bracket directly into the wall. If you are not

on a stud, insert the plastic anchor in the hole, and secure the bracket using the

screws supplied (Fig.10).

Fig. 10

Remove (4) screws and washers (Fig 11) from the unit to free the front cover.

Carefully lift the front cover off the unit a few inches. Disengage the ribbon cable

connecting the front cover LCD panel to the main control board or the unit (Fig

12). Remove the cover completely.

Please note: If LCD connection cable cannot be disengaged, simply set the front

cover

aside and keep the cable connected.

Fig. 11