User Manual

5. Before beginning any work on the electric installation, be sure that the main breaker
panel switch is OFF to avoid any danger of electric shock. All mounting and plumbing
must be completed before proceeding with electrical hook-up.
OPERATING INSTRUCTIONS
1. Turn on the circuit breaker to bring electrical power to the unit.
2. Open the water faucet for a few minutes until the water ow is continuous and all
the
air is purged from the water pipes. The unit must operate after the breakers are turned
on
3.After the unit is supplied with power, a beep sound can be heard and LED lights
appear
for 2 seconds; if there is no other display, the appliance keeps standby.
4. Press to turn ON/OFF the appliance. When the unit is ON, LED lights show the
actual outgoing water temperature. When the appliance stops working, after 5
seconds,
the screen switches on the screen saver. The display screen light will be o. If some-
body
touches the screen, the Iight will be on again.
5. Press and to adjust the outlet water temperature. Temperature setting
range is 30-52°C/ 86-125°F.
- If the unit has been paused, you may initially get a short burst of very hot water when
you turn it on again. Please run the water through for a few seconds to let the
temperature settle down. Please check the hot water with your hand before taking a
shower.
- If the unit is not used in winter, drain out the water completely so that the heater
does
not freeze.
- Please clean the inlet lter and the shower periodically in order to keep a proper
water ow.
6. Press to change the temperature display between Fahrenheit and Celsius
degrees.
7. There is an automatic memory function to avoid repetitive operation. When you turn
14