Instruction Manual

8
Marey Electric Tankless Water Heater by Wahlbach
9
EN EN
Mounting Instructions
Mounting Instructions
Marey Electric Tankless Water Heater by Wahlbach
Circuit diagram for PP15
L1
L2
Circuit diagram for PP18, PP24
Unpacking
Check if the device has been damaged in any way.
Contents
• 1 device
• 1 mounting template
• 1 bag of installation materials, contents:
①
1 filter mat
①
4 spacers
①
1 gasket
①
4 screws
①
4 anchors
Tools
You will require the following tools for the installation:
• Phillips-head screwdriver
• Open-ended spanner 7/8”
• Teflon tape
• Drill
• 5/16” stone or concrete drilling bits
• Pencil
• Adhesive tape
• Wire stripper
Environment
To prevent damage during transport this unit is supplied in robust packaging.
Please recycle the packaging where possible.
Disposal of the appliance
Old appliances must not be disposed of in your household waste!
Every consumer is legally obliged to dispose of old appliances separately from
their household waste and to take them, for example, to a collection point in
their local community or local district. Old electrical appliances will be accepted
there free of charge. This ensures that the old appliances are properly recycled
and any negative impacts on the environment are avoided. This is why electrical
appliances are marked with the symbol shown on the left.
Preparing for installation
The water and electricity supply need to be available at the place where the
device is to be supplied. If the electricity cable is buried in the wall then use the
supplied spacers. If the electricity cable is fixed to the wall then the device can
also be fixed straight to the wall.
The installation location for the appliance should keep away from the shower.
This appliance must be grounded properly!
Make sure taps/flow control device be install on the outlet of the appliance!
The appliance must be connected to a ground fault circuit interrupter.
A
B
C
D
E
A
B
C
D
E