User Manual

08
There are 2 Marey mini tank models, 2.5 and 4.0 gallon model. The water tank is welded,
glass lined steel and is equipped with an anode rod. The water heater is equipped with a
thermostat and a high temperature limit switch. A temperature pressure relief valve is
supplied with the unit.
3. TECHNICAL DESCRIPTION
MAREY TANK 2.5 (GALLON) / TANK 4.0 (GALLON)
The installation must be completed by a licensed professional. All state and local codes
must be adhered to. Marey will not be liable for any damages because of failure to comply
with these installation instructions or because of improper installation performed by an
unqualied installer.
CHOOSE A LOCATION
That allows ease of access for maintenance or servicing, ideally installed at least 9”
clearance at the top from the ceiling, cabinet, or any adjacent walls.
WALL MOUNTING
Fasten the supplied mounting bracket to the wall. Use screws that are suitable for
the wall material and the weight of the water heater lled to capacity (Marey Tank 2.5
(gallon)=37.5 lbs, Marey Tank 4.0 (gallon)=53.0 lbs). Hang the water heater on the bracket
and pull downwards on the water heater to ensure that both “ngers” of the bracket are
seated in the mounting slots.
Conrm your water piping orientation (hot and cold) before wall mounting. Only install in
vertical position. The heater can sit on the oor in a tray with a drain.
Conrm water piping orientation before nalizing on oor. Again, only install in vertical
position! Marey models Tank 2.5 gallon and Tank 4.0 gallon can be installed under the sink.
4. INSTALLATION INSTRUCTIONS
Installer should review the contents of this manual with the owner upon
completion of the installation, and the manual should remain with the
owner and placed in a location close to the water heater.
WARNING