Installation manual

MINI MAREY
AQUAMATIC
POWER GAS
SANTON
GAS PORTABLE POWER PAK
Water is coming out warm:
1. Check if there is a blue flame on the screen. If you see a yellow flame it could mean a
breakdown in the gas regulator. Please call Marey Heater Corp directly if this happens,
do not attempt to use it.
2. The unit is being operated at an altitude above 6,000 feet. The unit has been tested at
altitudes of more than 7,000 feet but we only recommend using it below elevations of no
more than 6,000 feet.
The unit starts for a short amount of time and then shuts off:
1. Check that the thermocouple is able to complete the circuit by checking that water is
flushed in the heat exchanger. If the heater shuts off is because the temperature is
either too low or high to complete its circuit.
2. Look if the gas sensors have come loose or check that it is properly connected.
3. If you run out of gas, have low gas, or your Propane gas cylinder is contaminated with
air (especially new tanks upon their first filling), then cycle the unit on and off by using
the shower head switch several times to purge the air from the gas.
4. Do not expose the water heater to strong winds.
5. This unit activates at a sustained water pressure of 5 PSI. If your house water
pressure is below the minimum the unit will not ignite. You will need a sustained water
pressure of approximately 40-60 PSI for an adequate use.
1110
Please visit our website to get to know more about other Marey products.
At Marey, we pride ourselves on the excellence of our customer service and support team.
Please feel free to contact us if you have any questions about our products, warranty
service, or if you need assistance installing a unit. We also strive for continuous
improvement, so we welcome your comments, feedback and s uggestions.
Perfect for Camping!
1-855-MAREY-55
[e-mail]
Delbrey Street, 211
San Juan, Puerto Rico
00912
Tel: [phone]
Toll Free: 1-855-627-3955
1-855-MAREY-55
www.marey.com