User Manual

16
NOTE: If your gas model features an LCD panel, the digital display will indicate the outgoing
water temperature.
This information is intended as a guideline based on typical residential environments.
Temperature increases will vary depending on the environment in which the heater is used.
Variables such as very low incoming water temperature or higher than average gas pressure
can result in higher temperature increases. Higher incoming water temperature or lower than
average gas pressure can result in lower temperature increases. ALWAYS test the water with
your hand to conrm suitable temperature before use.
Temperature increases listed are based on use of the water heater under optimal conditions
with an incoming water temperature of 48ºF. Variable factors such as incorrect or imperfect
installation or warmer incoming water temperature may yield different results.
9. TECHNICAL PARAMETERS
10. TEMPEARURE INCREASE CHART
* No need for electricity, starts with pulse ignition, powered by 2 D cell batteries.
Hot Water Outlet per Minute
Heat Loss
Exhaust Discharge Mode
Ignition
Uniform Energy Factor
Width x Height x Depth
Weight
Aplicable Water Pressure
Flue Duct Type
0.8
3.6 - 145.0 PSI / 0.25 - 10 bar
2D Cell Battery Powered
16 LPM / 4.3 GPM
100,000 BTU/h
16,5" x 27,9" x 8,2"
29 lbs
Related Gas Pressure (PSI)
2740 PA
Gas Type Liquid Propane
Activation Flow Rate
Maximum Flow Rate 4.3 GPM
0.75 GPM
TECHNICAL SPECIFICATIONS GA16OLPDP
Flue Duct Type
0.8
3.6 - 145.0 PSI / 0.25 - 10 bar
2D Cell Battery Powered
16 LPM / 4.3 GPM
105,800 BTU/h
16,5" x 27,9" x 8,2"
29 lbs
1740 PA
Natural Gas
4.3 GPM
0.75 GPM
GA16ONGDP
Temperature
Increase
GA16L
LPDP
NGDP
35 ºF 45 ºF 55 ºF 65 ºF
4.66
4.93
3.62
3.83
2.96
3.13
2.50
2.65
FLOW RATE (GPM)