Use and Care Manual

13
- Open the hot water on a nearby faucet. Conrm proper water ow through the unit and out
of the faucet. (You should hear a “clicking” sound from the unit-this is the ignitor activating).
Turn the water back off.
- Start the gas supply. Check again for gas leaks using soapy water and correct as necessary.
- Open the hot water faucet. You should hear the ignition clicking, and hot water should begin
owing. Sometimes, if there is air in either the water or gas supply lines, you will not get
immediate combustion. If this is the case, turn the water on and off several times to clear the
water and gas lines of any air pockets that may be present.
- All water heaters have a seasonal summer/winter switch to meet your water temperature
needs. This is because extra heating may be required when incoming water temperatures are
lower (winter), and less heating is required when incoming water temperatures are higher
(summer). Use the summer setting when incoming water temperatures are a little higher. Use
the winter setting when incoming water temperatures are a little lower.
- When the water supply is turned off, the water heater will stop working. When you turn the
water back on, the water heater will reignite. Please note that if you use the hot water
multiple times in quick succession, the water may be excessively hot for one or two seconds.
Please wait for the temperature to adjust before using.
- If you close the water inlet valve or the water outlet valve, the water heater will shut off
immediately. Shut off the gas supply after use.
6. OPERATING INSTRUCTIONS
Specification
Instruction
Sighting Window
Winter/Summer knob
Gas controlling knob
Water controlling knob
Drawing 06