® matey again GASH PR ENGAGE 1 ADELAIDE CS CANOEING INSTRUCTION MANUAL GAS STAINLESS WATER HERR HH Keep this manual with you after your unit has been installed, you may need it for further technical information.
® matey Congratulations! You've just purchased a new Mara Gas Flow standees water heater and will soon begin to enjoy the benefits of "going thankless” The availability of Instant hot water, combined with the unit's outstanding energy efficiency and space saving design, will quickly convince you that you've made the best decision for meeting your home's hot water needs, Take the time to thoroughly read and understand this safety and Installation manual in its entirety before you attempt to install your new
© QUICK START GUIDE oa PACKING LIST os IMPORTANT WARNINGS os FUNCTIONS AND FEATURES 08 INSTALLATION 08 OPERATING INSTRUCTIONS 3 INSTRUCTIONS FOR DAILY MAINTENANCE 14 CONSTRUCTION AND PART IDENTIFICATION 5 EXPLODED VIEW 1 TECHNICAL PARAMETERS 17 TROUBLESHOOTING GUIDE 18 CUSTOMER SERVICE 18
@ FEAR POWER GAS MODELS WARNING Working with gas can be dangerous, If you are not familiar with local building codes and basic gas plumbing practices please employ a professional to Install your water heater. 1. Securely mount your water heater to the wall in an appropriate location using the supplied hardware, 2. Install the venting (4” for the 51) per local building codes and the instructions supplied. 3. Connect the gas lines (all connections are Use yellow Teflon tape at threaded connections.
J PACKING LIST 1. WATER HEATER QTY 1 2 OPERATING INSTRUCTIONS QTY 4 3 MOUNTING SCREWS « 4 SETS @ IMPORTANT WARNINGS ~ You MUST install this water heater according to all directions and specifications contained In this manual.
Do NOT install the water heater in 2 sealed room of in & room with poor air circulation, You MUST install the exhaust pipe to proper discharge the exhaust gases. ~ Dio NOT block the exhaust pipe or the air inlet at any time. This can cause incomplete combustion and can lead to gas poisoning.
4. Low water pressure start up function: These unit requires fire, making t suitable for users with low water pres. sure, or those who are using it to supply hot water to upper floors, Please note that ‘the water flow and water pressure are not the same. Sufficient flow is always required to keep the overheat safety sensor from shutting the unit off, 5.
“Fie veer Gator pu nok Bi rain site. DRAWING 02 DRAWING 03 Z Don'tavpose the Walter heater to the strong wind or rain, 3. Use only the type of gas that is specified on the name plats. 4, All gas connections should be made by a professional. 5. Don't use pipes, tubing or other connections that are aging or cracked. &. Do net use with water pressures lower than 8 PSL Dre not use with lower GM's than indicated on the flow chart for your unit, 7.
2) When utilizing expansion screws for Sheetrock mounting, hold the unit on the wall where you want it mounted, Mark with a pencil the (4) mounting holes. Remove the unit from the wall, and drill 3/8" holes on sate mark. (See drawings below). ) Install the expansion bolt inch the drilled hole. Hang the unit utilizing the screws supplied.
HOT WATER OUTLET = The hot water outlet joint is 14° NPT pipe thread. The hot water outlet should be connected by flexible tubing or gid PYC of the type intended for use with hot water. The inner diameter of the water outlet pipe (including the valve) shouldn't be less than 3/8" Larger diameter pipe is acceptable as long as the appropriate adapters are used. = After connecting, fully open the cold water supply to confirm the flow of water and to check for leaks. Correct leaks as necessary.
This kind of damage will result in water running freely into the space where the water heater is located, with can cause flooding. IF your water heater is installed in a geo graphic location that sees very low sustained temperatures, you MUST terminate vent stack with a properly rated wind and rain cap, This will help prevent cold alr from falling down inch the water heater and causing freeze damage.
If horizontal runs are necessary then they must always be sloped up at least 25" for every foot and must be kept shorter than 75% of the total vertical length. Never terminate the venting horizontally, you need the last bit of vertical run to "pull® the remaining gasses that may have cooled in the horizontal run. If venting through the roof then the termination height will depend on your roof pitch (consult with an VAC tech if unsure of needed lengthen.
@ OPERATING INSTRUCTIONS Install two D Cell batteries, Check the door of the battery compartment for correct battery position. Open the hot water on a nearby faucet. Confirm proper water flow through the unit and out of the faucet. (You should hear a "clicking" sound from the unit-this is the inheritor activating). Turn the water back off. ~ Start the gas supply.
if swe 1. If a gas leak is detected at any time, close the main gas valve immediately. The Mara service center or your local gas company sou Id be contacted for repair DRAWING 06 2. Do not block the exhaust pipe or the alr Inlet, This can cause Incomplete combustion and lead to gas poisoning. 3. During operation, check the fire through the sight glass for normal combustion, Check for a compact, blue flame. Tall or excessively orange flames Indicate abnormal combustion.
Do NOT use strong detergents, benzene, gasoline, or other flammable agents to clean the unit. Regularly remove and wash the stainless steel filter in the cold water inlet. During operation, take note of the flame and discontinue use if abnormal combustion Is detected. Av old accidents. DO NOT modify this unit in any way.
@ TECHNICAL PARAMETERS Liquid Propane or Natural Gas Lipid Propane ar Natural Gas ARTURO 85000 BTU 158 5PM 6 LPM 264 GPM 10LPRA Flue Duct Type Flue Duct Type. #3 Cell Battery Powered strident 20 Cell Barter Powered ot incision 258 2583 25PSt116 PSI 25PS-NEPSH SLi win tS min Natural Gas: Natural Gas: 3.49 clobber Fea 10.48" 348" wcIOHIKPRY-I0 AB" W.ef2 Spay Liquid Propane; quid Propane: 6 well. WB HARPER) | 8" wc(lESKPRTZ OT" weld 231Pe) 142" HFT 142° NET NE HTS ET 12.9" X 215" X 7.
Please feel free fo contact us if you have any questions about our products, warranty service, or if you ends assistance installing a unit. ‘We also strive for continuous improvement, so we welcome your comments, feedback and suggestions. LL.5.A Mainland (855) 627-3955 Puerto Rico & Caribbean (787) 727-0277 www.
