Technical information

ITM18 18-6
original copywriter 1987
revised 07/04 - printed 2008
TECHNICAL INFORMATION
CIRCUIT CLAMP PLATE
WHEN SELECTED
W/O BUCKLE SIDE STRAP REMOVED
FIG.- 4 HOW TO RESET THE SYSTEM
• WHEN THE SYSTEM IS CORRECTLY RESET, THE DISPLAY GOES BLANK FOR A MOMENT THEN REAPPEARS AS
SHOWN FIG.-5.
FIG.- 5 DISPLAY AFTER THE SYSTEM RESET
• IF THE SYSTEM HAS NOT BEEN RESET THE DIVE COMPUTER MAY NOT FUNCTION CORRECTLY, SO BE SURE
TO RESET IT AND THEN CONFIRM CORRECT OPERATION OF FUNCTIONS.
NOTA
AFTER THE UNIT HAS BEEN RESET CORRECTLY, MEASUREMENT SYSTEM ENTERED “M” (IT IS DEFAULT
STATE). AT THE PLAN MODE, PUSH THE LOCK BUTTON FOR 15 SECONDS, SO THAT THE ALARM SOUNDS
ONE TIME, AND THE MEASUREMENT SYSTEM CHANGES TO “FT”.