User`s guide

Nemo Excel dive computer
4
which can be used to view additional
information, using the <+> or <-> buttons
(fig. 2):
• the date;
• the second time;
• the alarm;
• the temperature.
Note: these are the default display details.
Fig. 2
TIME MENU
From Time mode, press the <esc> button
to access the “Time Menu”, denoted by the
“Time” message on the display bar.
Press the <+> or <-> buttons to view the
contents of this menu (fig. 3).
Fig. 3
Time: displays the time. This is the default
operating mode. If no button is pressed after a
variable delay (which depends on the function),
Nemo Excel automatically reverts to this
mode.
Stopwatch: stopwatch timer function.
Watchset: sets all the “land” functions of your
Nemo Excel , as described in the following
pages.
NOTE
In Time Mode, if the wet contact is
activated the following icon appears
on the display. To preserve battery
life, always be careful to dry the
contact.
NOTE
Press and hold down the button + for
2 seconds to activate the display backlight.
TIME MENU SETTINGS
Watchset mode is used for setting all the
watch (“Time”) functions of your Nemo Excel
dive computer.
In this mode you can set the time and the
alarm. You can also enable and set up a
second time zone, which is useful when
traveling, and select the units of measurement
for temperature (°C or °F). Finally, in this
mode you can also set the audible alarms.
The different settings will all be described in
more detail subsequently. For now, we will
only describe setting the date and time of your
new Nemo Excel dive computer.
From the Time Menu, already described in the
preceding page, press the <+> or <-> buttons
until “Watchset” appears on the display bar.
Press the <enter> button to accept the
selection (fig. 4).
You are now in the Watchset menu.
Fig. 4
Press the <+> or <-> buttons to view the
various items in this menu on the display bar
(fig. 5).
Fig. 5
SETTING THE DATE AND TIME
Press the <+> or <-> buttons until “adj time”
appears on the display bar (fig. 6), and then
press <enter> to accept the selection.
Fig. 6
You can now set the date and time (fig. 7).
Fig. 7
In fact, as you will see, the digits of the
minutes start to blink. Use the <+> button
to increase the value, or the <-> button to
decrease. Press and release the button to
change the value by one minute at a time, or
hold down the button for rapid increment or
decrement.
After setting the minutes, press the <enter>
button to set the the hour, which is done in the
same way using the <+> or <-> buttons. Use
the same procedure to set the time format
(12h - 24h) and the date, beginning with the
day, followed by the month, and finally the year.
After setting the year, press the <enter> button
to save the changes made, after which Nemo
Excel automatically reverts to the Set Time
Menu. If you do not wish to make further
adjustments, press and hold down <esc> for
2 seconds to go back to Time Mode.
Your new Nemo Excel now shows the correct
time!