Installation manual

INSTALLING THE GAS LINE
STEP 5: Seal hole around gas line on refractory wall
with cement or
any other non-combustible
IMPORTANT: Install the gas line before finishing the material. (Figure 33).
fireplace. If desired, a decorative gas appliance may be
installed. Use only iron pipe, 112" size, and appropriate
STEP
6: Finish installation by either capping the gas
fittings. When installing gas line, a valve designed for
line or attaching a gas log,
installation outside the fireplace is required (Figure 31).
CAUTION: WHEN USING THE DECORATIVE
The unit is shipped from Ihe factory ready for installa-
tion. The
gas line may be installed to enter the fireplace
from either side. Refer
lo Figure 5 for hole location.
The gas line is intended for connection to a decorative
gas appliance incorporating an automatic shutoff device
and complying with the Standard for Decorative
Gas
Appliances for Installation in Vented Fireplaces, ANSl
221.60 Decorative gas appliance should be installed in
accordance with the National Fuel
Gas Cde. ANSl
2223.1. and NFPA 54.
BEFORE DOING ANYTHING, MAKE SURE THE GAS
VALVE LOCATED OUTSIDE YOUR FIREPUCE IS
SHUT OFF.
STEP 1: Remove gas line cover. Save screws. Re-
move insulation from inside gas conduit
sleeve. Save insulation.
t
SLEEVE ,
SCREWS
SIDE -GAS LINE
STEP 2: With gas line conduit sleeve in place strike the
back of
the refractory using a light punch.
STEP
3: Install a 7 inch minimum nipple to reach inside
the fireplace. Allow enough thread to install
cap (or elbow if continuing installation).
STEP
4: Repack insulation into conduit sleeve all
around nipple. Replace screws. (Figure
32),
APPLIANCE THE FIREPLACE DAMPER MUST
BE SET IN THE FULLY OPEN POSITION.
THIS INSTALLATION IS NOT LISTED BY
UNDERWRITERS LABORATORIES, INC,"
RADCO LAB. in accordance wIth ICBO require-
ments
and is approved for use with this fireplace
model.
INSTALLATION OF GAS
LOG LIGHTER
IF YOUR FIREPLACE IS PROVIDED WITH A GAS
LINE FOR ATTACHMENT TO A GAS LOG LIGHTER,
PLEASE FOLLOW THESE INSTRUCTIONS CARE-
FULLY.
1) BEFORE DOING ANYTHING, MAKE SURE THE
GAS VALVE LOCATED OUTSIDE YOUR FIRE-
PLACE IS SHUT OFF.
2) REMOVE THE CAP AT END OF GAS PIPELINE
PROTRUDING
FROM SlDE OF THE REFRAC-
TORY.
(SEE FIG. 33).
3) CONNECT FITTINGS:
TWO - 112 INCH DIA. 45" ELBOW
ONE
- 112 INCH DIA. CLOSE NIPPLE
4) INSTALL GAS LOG LIGHTER MAX. 24' LONG.
1/2 INCH DIAMETER TO ELBOW. (SEE FlG.33)
GAS LOG LIGHTER MUST BE INSTALLED FLUSH TO
ME HEARTH FLOOR OF YOUR APPLIANCE. DO
NOT ELEVATE GAS LOG LIGHTER.
YOUR
GAS LOG LIGHTER IS NOW READY FOR USE.