System information

Endurance Device Redirector 3-33
Updating Device Settings When Removing Ethernet Adapters
To update device settings when you remove an existing redirected Ethernet adapter:
21 In the Manufacturer column,
select Marathon, and in the
Network Adapter column,
select Endurance Ethernet
Redirector (MtcEthR) and click
Next.
Specifies that the network adapter is an Endurance
Ethernet Redirector.
22 Windows 2003: Click Next at the
The wizard is ready to install
your hardware dialog.
Windows 2000: Click Next at the
Start Hardware Installation
dialog.
The Endurance Ethernet Redirector is installed and
functional.
23 Click Finish.
24 Configure the adapter settings to
meet the requirements of your
site.
Step Action Notes
1 Run Endurance Manager and
make sure all device
components are in a Good state
and are displayed in green.
This procedure assumes the Endurance configuration is
in full working order before beginning.
2 Log onto CoServer 1 using an
account with Administrator
priviliges.
3 Select Start All Programs
Marathon Endurance
Mangement Tasks
Networking Replace
Redirected adapter (on
Windows 2000, use Start
Programs ... ).
Starts the Endurance Network Setup Wizard.
4 Reduce the count of adapters by
1 in the Specify total number of
Redirected adapters box.
You cannot remove the last redirected adapter. At least
one adapter must be configured at all times.
Step Action Notes