User guide

8
Preparing the Remote Control
Inserting batteries into the remote
control
1 Push down on the tab on the battery
compartment cover, and pull out in the
direction indicated by the arrow.
2 Insert batteries.
Make sure to match the plus (+) and minus
(–) polarity guides on the batteries with the marks
inside the battery compartment.
3 Close the cover.
Notes
• Do not mix old and new batteries.
• When replacing batteries, use all new batteries.
• When not using the remote control for a long period of time
(over 1 month), remove the batteries to avoid possible damage
from battery corrosion. If battery leakage occurs, wipe the
battery liquid from the battery component, then insert new
batteries.
Before Using
Checking Accessories
Please confirm that the following were received with the
player.
Audio cord
Video cord
(Yellow)
D-BUS remote cord
(Orange-colored)
Master-Slave control cord
Remote control unit
AA/R6P batteries
User guide (this manual)
Warranty card (U.S. and Canadian models only)
4
¢
1
¡
7
3
8
0
30°
30°
(16 ft.)
5 m
Remote control operation
When operating the remote control, point it at the remote
sensor located on the player’s front panel. The remote
control can be used up to 5 m (16 feet) from the player
and within a 30° angle on each side of the sensor.
Notes
• Exposing the remote sensor to direct sunlight or strong light
may cause faulty operation.
• When Master-Slave connections are made to another VC8100
to create a 601-disc changer, only the remote sensor on the
first VC8100 will accept signals from the remote control
(page 66).
• When using VC8100 independently, set REMOTE switch to
INTERNAL on the player’s rear panel (page 19).
Downloaded from www.Manualslib.com manuals search engine
Downloaded From Disc-Player.com Marantz Manuals