User guide

109
Basic versionSimple version Advanced version
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Information
GHDMIH
Symptom Cause/Solution Page
No audio is
output with HDMI
connection.
• Check the connection of the HDMI connectors.
• When outputting HDMI audio from the speakers, set “HDMI
Audio Out” on the menu to “AMP”.
• When outputting HDMI audio from a TV, set “HDMI Audio Out”
on the menu to “TV”.
16
77
77
No video is
output with HDMI
connection.
• Check the connection of the HDMI connectors.
• Set the input source to match the connected HDMI connector.
• Check whether the TV is compatible with copyright protection
(HDCP). If connected to a device not compatible with HDCP, video
will not be output correctly.
16
16, 25
15
When the following
operations are
performed on
devices compatible
with HDMI control,
the same operations
occur on this unit.
• Power ON/OFF
• Switching audio
output devices
• Adjust volume
• Switch input source
• Set “HDMI Control” on the menu to “OFF”. To operate power
only for each device, set “Power Off Control” to “OFF”.
52, 77
GRadioH
Symptom Cause/Solution Page
Reception fails, or
there is a lot of noise
or distortion.
• Change the antenna orientation or position.
• Separate the AM loop antenna from the unit.
• Use an FM outdoor antenna.
• Separate the antenna from other connection cables.
22
22
22
22
GM-XPortH
Symptom Cause/Solution Page
Audio is not output
when a wireless
receiver (RX101 is
connected).
• Check that the Bluetooth device and Wireless receiver (RX101)
are correctly paired.
–
GInternet radio / Media server / iPod / USB memory device / Flickr / Napster / Last.fmH
Symptom Cause/Solution Page
When a USB
memory device is
connected, “USB” is
not displayed on the
menu.
• The set cannot recognize a USB memory device. Check the
connection.
• A USB memory device not conforming to mass storage class or
MTP standards is connected. Connect a USB memory device
conforming to mass storage class or MTP standards.
• A USB memory device that the set cannot recognize is connected.
This is not a malfunction. Marantz does not guarantee that all USB
memory devices will operate or receive power.
• USB memory device is connected via USB hub. Connect the USB
memory device directly to the USB port.
20
–
–
–
Files on a USB
memory device
cannot be played.
• USB memory device is in format other than FAT16 or FAT32.
Set the format to FAT16 or FAT32. For details, refer to the USB
memory device’s operating instructions.
• USB memory device is divided into multiple partitions. When
divided into multiple partitions, only files stored in the top partition
can be played.
• Files are stored in a non-compatible format. Record the files in a
compatible format.
• You are attempting to play a file that is copyright protected. Files
that are copyright protected cannot be played on this set.
–
–
28
28
The file names
are not displayed
properly (“...”, etc.).
• Characters that cannot be displayed are used. This is not a
malfunction. On this set, characters that cannot be displayed are
replaced with a “
.
”.
–
Internet radio cannot
be played.
• Ethernet cable is not properly connected or network is
disconnected. Check the connection status.
• Program is being broadcast in non-compatible format. Only
Internet radio programs in MP3 and WMA can be played on this
set.
• The computer’s or router’s firewall is activated. Check the
computer’s or router’s firewall settings.
• Radio station is not currently broadcasting. Choose a radio station
that is currently broadcasting.
• IP address is wrong. Check the set’s IP address.
24
33
–
33, 34
79
Files stored on a
computer cannot be
played.
• Files are stored in a non-compatible format. Record in a compatible
format.
• You are attempting to play a file that is copyright protected. Files
that are copyright protected cannot be played on this set.
• Set and computer are connected by USB cable. The set’s USB
port cannot be used for connection to a computer.
33
33
–
Server is not found,
or it is not possible
to connect to the
server.
• The computer’s or router’s firewall is activated. Check the
computer’s or router’s firewall settings.
• Computer’s power is not turned on. Turn on the power.
• Server is not running. Launch the server.
• Set’s IP address is wrong. Check the set’s IP address.
• Connecting to the media server may take a few minutes the first
time you attempt to make a connection.
–
–
–
79
–
iPod cannot be
played.
• Some iPods do not support being used connected directly to the
USB port.
20
1.SR7005N_ENG_0619校了_0622修正.indd 109 2010/06/22 13:55:13