User guide

62
(1*/,6+ '(876&+ )5$1d$,6 ,7$/,$12 (63$f2/ 1('(5/$1'6 69(16.$(1*/,6+ '(876&+ )5$1d$,6 ,7$/,$12 (63$f2/ 1('(5/$1'6 69(16.$
Other settings
Remote control settings
• When you connect a remote control receiver unit (purchased
separately) to the REMOTE CONTROL IN terminal of this unit, use
the following procedure to disable the remote sensor function of
this unit.
• The remote sensor function of remote control signals is enabled by
default.
o p
ZONE2 ON/OFF
RETURN
ENTER
n Disabling the sensor function of the remote control
1
7RHQDEOHWKHUHPRWHVLJQDOVHQVRUIXQFWLRQSUHVV
DQGKROG
ZONE2 ON/OFFDQGRETURNIRUVHFRQGV
“IR:< ENABLE >” is displayed.
2
3UHVVopWRVHOHFW³',6$%/(´
3
3UHVVENTER
The sensor function of the remote control signal of this unit is
disabled.
NOTE
If a remote control receiver unit (purchased separately) is not
connected, do not perform this setting. If you do, you will not be
able to operate this unit using the remote control.
n Enabling the remote sensor function
1
7RGLVDEOHWKHUHPRWHVLJQDOVHQVRUIXQFWLRQSUHVV
DQGKROG
ZONE2 ON/OFFDQGRETURNIRUVHFRQGV
“IR:< DISABLE >” is displayed.
2
3UHVVopWRVHOHFW³(1$%/(´
3
3UHVVENTER
The sensor function of the remote control signal of this unit is
enabled.
Switching the on-screen display
output mode
Set whether the menu is operated by the monitor connected to the
VIDEO OUT terminal or the monitor connected to the COMPONENT
VIDEO MONITOR OUT terminal.
• The factory setting is “Comp”.
ENTER
o p
RETURN PURE DIRECT
1
3UHVVDQGKROGRETURNDQGPURE DIRECTIRU
VHFRQGV
Corresponding to the video signal format settings,
“OSD Out: 0 Comp 1” or “OSD Out: 0 Video 1” is shown
in the display.
2
3UHVV o p WR FKDQJH WKH VHWWLQJV DFFRUGLQJ WR WKH
FRQQHFWLRQPHWKRG
Comp
Set when the COMPONENT VIDEO MONITOR OUT
connector is connected to a TV.
Video
Set when the VIDEO OUT connector is connected
to a TV.
3
3UHVVENTER WRHQWHUWKHVHWWLQJ
NOTE
When operating the on-screen display menu using the monitor
connected to the HDMI OUT terminal, either setting may be used
without problem.