ESPAÑOL FRANÇAIS Receiver SR4023 ENGLISH
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. Additional Safety Information! • This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.
TABLE OF CONTENTS Thank you for purchasing the Marantz SR4023 Receiver. This remarkable component has been engineered to provide you with many years of listening enjoyment. Please take a few minutes to read this manual thoroughly before you connect and operate the SR4023. As there are a number of connection and configuration options, you are encouraged to discuss your own particular system setup with your Marantz authorized dealer. INTRODUCTION ....................................1 ADVANCED CONNECTIONS .
ENGLISH NAMES AND FUNCTIONS FEATURES BEFORE USE ■ High quality full discrete power amplifier This section must be read before any connection is made to the mains supply. 80W+80W (8 ohms, 20 Hz – 20 kHz, 0.08% THD) BASIC CONNECTIONS ■ Speaker A/B switching EQUIPMENT MAINS WORKING SETTING ■ Four A/V inputs (DVD, DSS, VCR and AUX) Your Marantz product has been prepared to comply with the household power and safety requirements that exist in your area. SR4023 can be powered by 120V AC only.
2. Load the two new size “AAA” batteries inside the battery compartment while taking care to align their polarities correctly with the polarity markings ( with ( and with ). 3. Close the battery cover until it clicks shut. 5m 60° SR4023 Remote controller Caution: • Do not allow direct sunlight, an inverter fluorescent light or other strong source of light to shine onto the player’s infrared receptor window. Otherwise, the operation of the remote controller may be disabled.
ENGLISH !1 NAMES AND FUNCTIONS NAMES AND FUNCTIONS TUNING/PRESET 34 (UP/DOWN) button This button used for tuning in the desired broadcasting stations or to preset in the desired broadcasting stations. FRONT PANEL q w er tyu i BASIC CONNECTIONS !2 BAND button Press this button to switch between FM and AM in the TUNER mode. RECEIVER SR4023 UP DISP AUTO SLEEP TUNED !3 ST DIRECT SPKR B DOWN BASIC OPERATION INPUT SELECTOR S.DIRECT DIMMER F/P BAND VOLUME TUNING/ PRESET T.
ST DIRECT SPKR B h a DISP (Display Off) indicator f DIRECT (Source direct) indicator This indicator is illuminated when this unit is in the display off mode. This indicator is illuminated when this unit is in the SOURCE DIRECT mode. s g SLEEP timer indicator This indicator is illuminated when the sleep timer function is in use. d TUNER’s indicators AUTO : This indicator illuminates when the tuner’s Auto mode is in use.
ENGLISH NAMES AND FUNCTIONS z REMOTE CONTROLLER BASIC CONNECTIONS The provided remote controller is a system remote controller. The POWER button, numeric buttons and control buttons are used in common across different input source components. The input source controlled with the remote controller changes when one of the input selector buttons is pressed. z ¤1 x BASIC OPERATION c ADVANCED CONNECTIONS ¤0 ⁄9 ADVANCED OPERATION ⁄8 v b n m , POWER ON and OFF buttons .
y u o ANTENNA AC OUTLETS 120V 60Hz UNSWITCHED 1.25A 150W GND DSS AM AUX VCR MONITOR FLASHER IN RS-232C !0 SWITCHED 1.25A 150W AC IN IN IN IN GND IN OUT VIDEO R SYSTEM A L MODEL NO.
ENGLISH CONNECTING VIDEO COMPONENTS NAMES AND FUNCTIONS BASIC CONNECTIONS VCR CONNECTING AUDIO COMPONENTS Monitor Turn table BASIC CONNECTIONS ANTENNA FM (75 75Ω Ω) GND AUDIO OUT AUDIO IN L R L R VIDEO OUT IN AM DVD DSS AUX IN IN IN VCR MONITOR FLASHER IN RS-232C VIDEO IN CVBS PHONO L R OUT GND IN OUT L OUT R L R VIDEO R BASIC OPERATION AUDIO L PHONO CD player CD DVD DSS AUX IN IN IN IN VCR RECORDER 1 (CD-R CD-R)) RECORDER 2 (TAPE TAPE)) L L R R L R
CONNECTING SPEAKER WIRE CONNECTING SPEAKERS Right 1. Left CONNECTING A SUBWOOFER Use the PRE OUT SUBWOOFER jack to connect a powered subwoofer (power amplifier built in). 2. System A NAMES AND FUNCTIONS ENGLISH 3. 4. 5. ANTENNA AC OUTLETS 120V 60Hz UNSWITCHED 1.25A 150W FM (75 75Ω Ω) DVD GND DSS AM AUX VCR MONITOR FLASHER IN RS-232C SWITCHED 1.25A 150W BASIC CONNECTIONS 10 mm (3/8inch) AC IN IN IN IN GND IN OUT OUT AUX VCR L MODEL NO.
ENGLISH NAMES AND FUNCTIONS CONNECTING THE SUPPLIED ANTENNAS CONNECTING THE ANTENNA TERMINALS AM Loop Antenna FM External Antenna FM Antenna AM External Antenna CONNECTING THE AC POWER CABLE Connecting the supplied FM antenna The supplied FM antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion.
ENGLISH AMPLIFIER OPERATION • When a Video source is selected, the video signal for that input will be routed to the Monitor Output jack and will be viewable on a TV monitor connected to the SR4023. TEMPORARILY TURNING OFF THE SOUND NAMES AND FUNCTIONS BASIC OPERATION UP ND ADJUSTING THE MAIN VOLUME TURNING ON THE UNIT R SR DOWN To turn on the power with the remote controller, first press the AMP button and then press the POWER ON or SOURCE POWER button on the remote controller.
ENGLISH NAMES AND FUNCTIONS MANUAL TUNING TUNER OPERATION 1. LISTENING TO THE TUNER BASIC CONNECTIONS Frequency scan step for AM is selectable. Default setup is 10 kHz step, if your country’s standard is 9 kHz step, Press BAND button on the remote controller more than 6 seconds. Scan step will change. (FM) TUNING MODE (AUTO STEREO OR MONO) 2. RECEIVER SR4023 UP RECEIVER SR4023 DISP BASIC OPERATION MULTI AUTO AUTO SURR TUNED DIRECT ST V – OFF DISC 6.1 NIGHT MTX 6.
CONNECTING PRE OUT JACKS ADVANCED CONNECTIONS If you use a power amplifier, connect it as shown below, and then you can use this unit as a pre amplifier. To connect speaker systems, refer to the instruction manual supplied with the power amplifier to be used. If you use a pre amplifier, connect it as shown below, and then you can use this unit as a power amplifier. For details on operations of the pre amplifier, refer to the instruction manual supplied with the pre amplifier to be used.
ENGLISH NAMES AND FUNCTIONS CONNECTING THE REMOTE CONTROL JACKS ANTENNA AC OUTLETS 120V 60Hz UNSWITCHED 1.25A 150W FM (75 75Ω Ω) DVD GND DSS AM AUX VCR MONITOR BASIC CONNECTIONS FLASHER IN RS-232C SWITCHED 1.25A 150W AC IN IN IN IN GND IN OUT OUT VIDEO R SYSTEM A L MODEL NO.
In normal operation, the audio or video source selected for listening through the SR4023 is sent to the record outputs. This means that any program you are watching or listening to may be recorded simply by placing machines connected to the outputs for RECORDER1 OUT, RECORDER2 OUT, and VCR OUT in the record mode. To record the input source signal you are currently watching or listening to To program this unit for automatic standby, press the SLEEP button on the remote controller.
ENGLISH NAMES AND FUNCTIONS TUNER OPERATION (PRESET MEMORY) MANUAL PRESET MEMORY 3. 2. 4. With this unit you can preset up to 50 FM/AM stations in any order. For each station, you can memorize the frequency and reception mode if desired. DIRECT ST V – OFF DISC 6.1 NIGHT MTX 6.1 PEAK ATT ANALOG SPKR B EQ DIGITAL DIGITAL L BASIC CONNECTIONS 3. SURROUND C R LFE PCM SL S SR 2. 4. TUNING/ PRESET BASIC OPERATION TUNED ST V – OFF DISC 6.
SORTING PRESET STATIONS NAME INPUT OF THE PRESET STATION. RECEIVER SR4023 UP PEAK ATT ANALOG SURROUND SPKR B EQ DIGITAL DIGITAL NIGHT MTX 6.1 L C R LFE PCM SL S S.DIRECT DIMMER F/P BAND TUNING/ PRESET 4. 5. 2. 5. 6. VOLUME T.MODE A → B → C ... Z → 1 → 2 → 3 ..... 0 → – → + → / → (Blank) → A SR DOWN INPUT SELECTOR MEMORY CLEAR MUTE UP → RECEIVER SR4023 PHONES ← DOWN UP DISP MULTI SLEEP AUTO AUTO SURR TUNED DIRECT ST V – OFF DISC 6.1 NIGHT MTX 6.
ENGLISH NAMES AND FUNCTIONS REMOTE CONTROLLER OPERATION THE CONTROLLABLE FUNCTION TABLE BUTTON NAME BASIC CONNECTIONS BASIC OPERATION ADVANCED CONNECTIONS ADVANCED OPERATION TROUBLESHOOTING OTHERS 18 REMOTE CONTROL CODE SETTING FUNCTION CD DVD TAPE SOURCE POWER POWER ON / Standby POWER ON / Standby POWER ON / Standby 2 Starts playback Starts playback Starts playback 9 Stops playback Stops playback Stops playback SLEEP / ; Pauses a disc that's playing Pauses a disc that's playing Pause
S.DIRECT F/P T.MODE MUTE RECEIVER SR4023 In case of trouble, check the following before calling for service: UP Are the connections made properly ? Are you operating the unit properly following the user’s guide ? Are the power amplifiers and speaker working properly ? DISP MULTI SLEEP AUTO AUTO SURR TUNED DIRECT ST V – OFF DISC 6.1 NIGHT MTX 6.1 PEAK ATT ANALOG SPKR B EQ DIGITAL SURROUND DIGITAL L C R LFE PCM SL S SR DOWN INPUT SELECTOR S.
ENGLISH DIMENSIONS CLEANING OF EQUIPMENT EXTERNAL SURFACES 7/8 ins. (22 mm) NAMES AND FUNCTIONS OTHERS TECHNICAL SPECIFICATIONS 3/4 ins. (17.5 mm) Rated Power ................240 Hz – 20 kHz 8 ohms 80 W/Ch 6 ohms 100 W/Ch 240 Hz – 20 kHz 4 THD .................................40 2 Hz – 20 kHz 8 ohms 0.08% Input Sensitivity/Impedance Linear ...........................................200 mV/47 kohms Signal to Noise Ratio (IHF A) Linear ..............................................................
www.marantz.com You can find your nearest authorized distributor or dealer on our website. is a registered trademark.
