Owner's Manual

Connect and playback from a digital
device (Coaxial/Optical)
1
Press DISC/INPUT to switch the playback
media mode to “Coaxial” or “Optical”.
The digital audio signal that is being input is shown as
follows in the display.
“Coax:xxxxk” or “Opt:xxxxk”
(xxxx is the sampling frequency.)
0
If the sampling frequency cannot be detected,
“Unlock
” will be displayed.
0
“Unsupported” is displayed when audio signals that
are not supported by this unit are input.
n
Specifications of supported audio
formats
See “D/A converter” (v
p. 39).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, and
DTS. This causes noise and could damage the speakers.
Specifying the desired sound
quality
Switching the filter characteristics
This unit is equipped with a sound quality adjusting function
which allows users to enjoy the desired playback sound
quality. The unit supports PCM signal.
The 2 filter characteristics types are explained below.
Filter Type Characteristic
Filter 1 Very short but symmetrical impuls response.
Very precise soundstage and smooth tonal
balance.
Filter 2 Very short pre-ringing - long post-ringing.
Phase compensated analog filter. Neutral tonal
balance - slightly brighter than
“Filter1”.
1
Press FILTER
The setting cycles through the 2 modes (Filter 1 / Filter
2) as shown below each time the button is pressed.
NOTE
0
The filter characteristics have a last memory function.
These settings remain in memory even if a disc change
occurs, or if the power is turned off.
0
The filter function does not work during playback of Super
Audio CDs or DSD audio sources.
ENGLISH
24
Overview Connections Playback Settings Tips Appendix
Printing:Color:Black