Owners Manual
Wireless LAN
When connecting to the network via wireless LAN, connect the external
antennas for Bluetooth/wireless connectivity connection to the rear panel
and stand them upright.
See “Wi-Fi Setup” on how to connect to a wireless LAN router.
(v p. 88)
.
COAXIAL
COAXIAL
OPTICAL
OPTICAL
DIGITAL AUDIO IN
DIGITAL AUDIO IN
AUDIO IN
AUDIO IN
CD
CD
AUX
AUX
RECORDER
RECORDER
PHONO
PHONO
SIGNAL
SIGNAL
GND
GND
AC IN
AC IN
AUDIO OUT
AUDIO OUT
PRE OUT
PRE OUT
RECORDER
RECORDER
SUBWOOFER
SUBWOOFER
Internet
Modem
To WAN side
Router with access point
0
When using this unit, we recommend you use a router equipped with the following
functions:
0
Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
0
Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a
speed of 100 Mbps or greater.
0
Only use a shielded STP or ScTP LAN cable (readily available at electronics
stores). (CAT-5 or greater recommended)
0
The normal shielded-type LAN cable is recommended. If a flat-type cable or
unshielded-type cable is used, other devices could be affected by noise.
0
When using this unit connected to a network with no DHCP function, configure the
IP address, etc. in “Network”. (v p. 86)
NOTE
0
The types of routers that can be used depend on the ISP. Contact your ISP or a
computer shop for details.
0
This unit is not compatible with PPPoE. A PPPoE compatible router is required if
your contracted line is not set using PPPoE.
0
Do not connect a NETWORK connector directly to the LAN port/ Ethernet
connector on your computer.
0
Various online services may be discontinued without prior notice.
Contents Connections Playback Settings Tips Appendix
33
Front panel Rear panel
Remote control
unit
Index