Service manual

5. DISASSEMBLY

In case of trouble, etc., necessitating dismantling, please

dismantle in the order shown in the illustrations. Reassemble

in the reverse order.

1. Removal of the UPPER COVER

2. Removal of the FRONT PANEL

1) Press the “EJECT” button while the unit’s power is turned on and open the DISC TRAY.

2) Remove the decoration plate on the DISC TRAY by pulling it upward.

3) Remove the three retaining screws on the bottom and two screws on each left and right side of the FRONT PANEL as

shown.

4) Disconnect the flat cable from the P702 connector on the OUTPUT PCB .

5) Remove the FRONT PANEL by pulling it forward while releasing the TABs on both left and right ends of the FRONT

PANEL.

TABTAB

P702

REMARK : Before disassemble the front panel.

Press open/close button to open the tray.

If the tray doesn’t work, put a small screwdriver into the

hole as shown in picture and slide the knob.

Then the tray comes out. After the first centimeter it is

possible to pull the tray out by hand. Release the door

cover of the tray.