Service manual

U1B F1N N1B S1G K1G

01 02 02 04 20

Data

10. Press the “ ENTER “ button, then address data will be

memorize and the FLD shows a data number which you

stored. ( EX: “ D-02 “ )

11. Turn OFF the mains switch, then EEPROM initialization

mode will be release.

7. Turn ON the mains power while depress the “ DIMMER “

and “ “ (Reverse skip) buttons together. Then the FLD

shows “ -- -- -- -- “.

8. Send the commands “ 1999 “ by the remote controller.

(Press buttons “ 1 “, “ 9 “, “ 9 “ and “ 9 “.) Then the FLD

shows “ A-00 D-XX “. (XX = is depended on EEPROM

status)

9. Send the commands “ D-XX “ (Data) as your product ver-

sion shows in following table by the remote controller.