Service manual

U1B F1N N1B S1G K1G

01 E1 E9 F7 E7 E7

02 30 30 70 30 30

03 00 08 00 00 06

04 53 50 00 00 00

05 55 4A 00 00 00

06 C5 C5 C5 C5 C5

07 A9 A9 A9 A9 A9

Address

Data

8-3. EEPROM initialize

The memory device (EEPROM) which used in this DVD player

is programmed each functions by products regions at factory.

When that EEPROM (MAIN P.C. Board IC602 : M24C16-

MN6T) or MAIN P.C. Board has exchanged, EEPROM initial-

ization is necessary. If that the initialization will not be done

correctly, the product might not be work correctly.

The initialize procedure are as follows.

1. Remove any Disc from the tray, and turn OFF the mains

power.

Turn ON the mains power while depress the “ “ (STOP)

and “ “ (Forward skip) buttons together. Do not release

buttons till FLD shows “ A-01 D-XX “. (XX = is depended

on EEPROM status)

REMARK : In case of some failure with the product. The

ERROR code will be shown on the FLD and above

indication will not be shown. Then other confirmation or

repair is necessary before this EEPROM initialization.

2. The address shown as “ A-01 D-XX “ is can be changed

by pressing “ “ and “ “ buttons on the front panel or

remote controller. Which can be changed to “ 0 “ till “ 07 “.

(Address “ 00 “ is not available.)

“ “ (Forward skip) button : Address UP

“ “ (Reverse skip) button : Address DOWN

3. The DATA shown as “ XX “ is can be changed by pressing

“ II “ and “ “ buttons on the front panel or remote

controller. Set up data are shown in following table.

“ II “ (PAUSE) button : Data UP

“ “ (STOP) button : Data DOWN

4. Press the “ DIMMER “ button, then address data will be

memorize.

5. Memorize data by each address ( from “ 01 “ to “ 07 “), as

order 2., 3. And 4. processes.

6. Turn OFF the mains switch. (This procedure is necessary

for next procedure.)