User guide

ManualsBrandsMarantz ManualsTV TunerDV110

ENGLISH

7. Press the ENTER button @4 to enter the selection.

Or push the ENTER button ,.

The time set on the display now flashes. (Second setting)

8. Finally when the ENTER button @4 on the remote control

unit is pressed, the time starts from 00 seconds.

Likewise, push the ENTER button , to set the second.

• The entered time appears for 3 seconds, and then the

original display is restored.

TIMER PLAYBACK

This unit can play a disc or tuner at a specific time by setting the

playback time. The ON time and OFF time are set for timer

playback.

1. Press the TIMER button @9 on the remote control once.

On the display, "On Time" appears first followed by the time,

and the hour flashes. (Playback ON hour setting)

↓

2. Set the playback ON hour using the Cursor ( 1 / 2 ) buttons

!1 on the remote control or the Cursor ( 1 / 2 ) buttons . on

the main unit.

3. Press the ENTER button @4 to enter the selection.

Or push the ENTER button ,.

• The setup hour appears on the display, and the minute

flashes. (Playback ON minute setting)

Blink

USING THE TIMER FUNCTIONS

This unit enables a time to be set and for a disc to be played at

this setting. The clock must always be set for the timer functions

to be valid.

Note :

These functions work only when the unit is used on its own.

The PS110's timer functions are used when the unit is

operating as part of a system with the PS110.

SETTING TIME

1. Press the TIMER button @9 on the remote control for at least

3 seconds.

"12/24" now appears on the display, and "12" starts

flashing.

2. Select the 12-hour or 24-hour time display using the Cursor

( 1 / 2 ) buttons !1 on the remote control or the Cursor ( 1 /

2 ) buttons . on the main unit.

3. Press the ENTER button @4 to enter the selection.

Or push the ENTER button ,.

The time now appears on the display, and the hour flashes.

(Hour setting)

4. Set the current hour using the Cursor ( 1 / 2 ) buttons !1 on

the remote control or the Cursor ( 1 / 2 ) buttons . on the

main unit.

5. Press the ENTER button @4 to enter the selection.

Or push the ENTER button ,.

The time now appears on the display, and the minute

flashes. (Minute setting)

6. Set the current minutes using the Cursor ( 1 / 2 ) buttons !1

on the remote control or the Cursor ( 1 / 2 ) buttons . on

the main unit.

Blink