User guide

8
ENGLISH
REAR PANEL
A AM antenna terminal
• To connect the supplied AM loop antenna, use the terminals
marked "AM" and "GND". (
☞
p10)
• In areas where the AM loop antenna gives unsatisfactory
results, it is recommended that the receiver be connected to
an outdoor antenna. Use the terminal marked 'AM' for this. A
grounding lead can be connected to the terminal marked
'GND' to further reduce interference. In this case, it must be
connected together with the supplied loop antenna.
B Analog output jacks
• Connect to the audio input jacks of an amplifier.
C Video input jack
• Connect to the video signal output terminals of a video
equipment (TV-Tuner, VCR, etc.).
Note:
This video input jack is used only when the player is system-
connected with PS110. This jack cannot be used when the
player is used in stand-alone.
D System selector switch
• This switch selects the system operation mode.
• Set to EXT position when DV110 is being used in combination
with a AV amplifier (PS110), CDR (DR110) or MD (MD110).
• If your component is not capable of system connection, set
this switch to INT position.
E S-Video output jack
• Connect to the S-video input terminals of an AV amplifier,
VCR.
F Digital out COAX jacks
• The DVD , CD signals during playback are output digitally to
these jacks.
• Connect these jacks to a PS110 DVD (digital) input or other
recorder component with coaxial digital input jacks.
G Scart connector (Euroconnector)
• Euroconnector for connection to a TV with euroconnector.
• The video signal formats output from the SCART terminal are
S-Video and Composite. RGB signal is not supported.
H Power cord cable
• Connect this to a household AC 230 V outlet.
I FM antenna terminal
• For connecting an external FM antenna with a circular plug,
or for connecting a cable network. (
☞
p10)
J Remote control jacks
• Connect to a component equipped with remote control jacks.
(
☞
p9)
K Video output jack
• Connect to the video input terminals of an AV amplifier, VCR.