User's Manual

5
Setup
Items not listed under Introduction > Box Contents are sold separately.
Example 1 – Mono Operation
To send a mono signal from a single transmitter to the receiver:
1. Connect your microphone to the mic input on the transmitter, and connect the
receiver’s audio output to your camera’s external mic input. Keep the volume
controls on the camera at its minimum settings.
2. If necessary, adjust the RF dB level on the transmitter to get a strong signal for
better operating range and noise resistance.
3. Turn on your camera, adjust the RX output level on the receiver and the input level
of the camera’s external mic input to hear the audio signal (or view the level on the
input level of the camera).
4. In the audio recording settings on your camera, make sure it is set to Manual rather
than Auto. Check the input level meter, and adjust the level so that the loudest
sounds peak around -12 dB. Make sure the sound does not exceed 0 dB, which will
cause the signal to distort.
Receiver
Transmitter
Camera Mic
Input
Receiver
Transmitter Camera
Mic
Input