Owner`s manual

16
17
8-16. INITIAL SYSTEM SET UP (cont’d)
8-17. ADVANCED SETTINGS
Advanced settings p
rogramming flow chart
(Diagram illustrates: Level 2, Menu 2)
End
programming
ParameterMenu
Operating
mode
Levels
+
-
+
-
+
-
+
-
Level 3
> 10 sec.
P
+
-
+
-
+
-
Level 4
Level 2
+
-
Level 8
+
-
Levels Exit
P
P
P
> 5 sec.
P
Menu 1
Menu Exit
(Level
2)
+
-
Menu 2
+
-
Menu 3
+
-
Menu 8
Parameter
Increase
value
Reduce
value
P
P
P
+
-
Level 1
+
-
+
-
+
-
+
-
> 5 sec.
P
> 5 sec.
P
(Continue to levels
5, 6, 7)
Levels 3, 6, 7 are disable
Additional operator functions can be set using the
advanced operator functions. Parameters factory
default settings can be restored. This programming may
only be carried out by a professional installer.
1
5
3
7
2
4
6
8
1
5
3
7
2
4
6
8
1
5
3
7
2
4
6
8
1
5
3
7
2
4
6
8
P
P
1
5
3
7
2
4
6
8
1
5
3
7
2
4
6
8
+
-
+
-
1
5
3
7
2
4
6
8
1
5
3
7
2
4
6
8
Legend:
LED
off
LED on
LED flashes slowly
LED pulses
LED flashes quickly
Factory default setting
Not possible
–
Power on
+
-
1x >2s< 10s
1
5
3
7
2
4
6
8
1x <1s
1
5
3
7
2
4
6
8
1
5
3
7
2
4
6
8
1
5
3
7
2
4
6
8
P
1x <1s
P
1x <1s
1
2
3
4
5
6
7
8
9
10
1
5
3
7
2
4
6
8
Operating
mode
Start initial system setup by
programming the door OPEN
position.
Bring the door to the desired
OPEN postion
Fine adjustment if necessary.
Adjust the OPEN door position
using (+) and (-)
Save the OPEN door position.
Start programming the
CLOSED door position.
Bring the door to the desired
CLOSED position
Fine adjustment if necessary.
Adjust the CLOSED door
position using (+) and (-)
Save the CLOSED door
position. Program the
transmitter code to GDO
Press the transmitter
button. LED #7 flashes rapidly
Release the transmitter button
Save the transmitter code
settings. End the system setup
(programming) procedure
IMPORTANT: SEE NOTE
BELOW
IMPORTANT:
Upon completion of the initial set up, the operator
must be cycled for two complete cycles (complete
cycle comprises of one uninterrupted up activation
of the system and one uninterrupted down
activation of the system).