User guide

Index
1010-0096, Rev 04
Index
!
3-Wire RS-485 30
Interactive & Block modes 15
Limitations 19
Network mode 19
5-Wire RS-485
Interactive & Block modes 15
Network mode 18
B
Baud Rate 24
Block Mode 36
Disable Block Mode control command A-7
Enable Block Mode control command A-8
Keyboard Input Buffer 36
C
Cable 1
Command Terminator
in Control Commands A-1
in Network Mode 37
Configuration 21
Append Linefeed 28
Baud Rate 24
Block Echo 29
Cursor Type 31
Delayed Linefeed 30
Local Echo 29
Network Address 31
OIT Display Brightness or Viewing Angle 24
Operating Parameters 24
Parity 25
Stop Bits 25
Tab Width 31
Turn-Around Delay 29
Wrap Around 32
Configuration Mode 10, 21
Local Setup 33
Connecting Your OIT to the Host Controller 15
RS-232 (Interactive & Block modes) 15
RS-422/485 (Interactive & Block modes) 15
RS-422/485 (Network mode) 16
Control Codes B-1
BEL B-1
BS B-1
CAN B-1
CR A-2, B-1
ENQ B-1
ESC A-2
ETX A-2
FF B-1
HT B-1
LF A-2, B-1
STX A-2
VT B-1
XOFF B-1
XON B-1
Control Commands A-1
Clear Output Buffer A-5
Create Display Variable A-9
Disable Block Mode A-8
Display and Cursor Format Control A-3
Display Format A-3
Display Message A-5
Echo Back Text A-5
Enable Block Mode A-8
Enable Handshaking A-4
Function Key Control A-6
Function Key LED A-7
Keyboard Control A-3
Line Terminator A-1
Poll OIT Buffer A-6
Print Screen A-6
Print Text A-6
Read Cursor Position A-9
Read Display Variable A-8
Request Configuration Data A-3
Request Keyboard Buffer Status A-7
Retransmit Last Keyboard Buffer A-6
Save Configuration Parameters A-2
Screen Function Key Control A-6
Set Communications Parameters A-4
Set Cursor Position A-9
Set LCD Viewing Angle or Brightness Level A-2
Set Line Terminator A-5
Set Operating Mode A-4
Set Tab Character Width A-4
Set Turn-Around Delay A-4
Sound Bell A-5
Status LED A-7
System LED A-7
Cursor Type 31
D
Data Bits 25
Display 41
Display Brightness 24
Display Viewing Angle 24
Displaying Text from Predefined Messages 44
Displaying Text from the Host Controller 43
Displaying Text from the OIT’s Keypad 41
Using a Display Variable 43
Display Brightness 24
Display Variable 43
Create Display Variable control command A-8
Read Display Variable control command A-8
Write Display Variable control command A-8
Display Viewing Angle 24
Download STEPware-100 Project to Your OIT 9
Download/Upload Mode 10, 22