User Manual

Page 71 1010-1023, Rev 00
5.3.4 SATA Configuration
Use the SATA Configuration menu (621HBIOS Menu 6) to change and/or set the
configuration of the SATA devices installed in the system.
Aptio Setup Utility – Copyright (C) 2011 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [IDE]
SATA1 Port Empty
SATA2 Port Empty
SATA3 Port Empty
SATA4 Port Empty
Enable or disable SATA
Device.
---------------------
 : Select Screen
 : Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
BIOS Menu 6: SATA Configuration
 SATA Controller(s) [Enabled]
Use the SATA Controller(s) option to configure the SATA controller(s).

Enabled
DEFAULT
Enables the on-board SATA controller(s).

Disabled
Disables the on-board SATA controller(s).
 SATA Mode Selection [IDE]
Use the SATA Mode Selection option to configure SATA devices as normal IDE devices.

IDE
DEFAULT
Configures SATA devices as normal IDE device.

AHCI
The SATA drive connected to the nth SATA drive port is
specified as a normal SATA drive.