User Manual

1010-1023, Rev 00 Page 38
Step 4: Secure the PC400C Series Panel PC to the interface pad by inserting four
retention screws through the mounting arm interface pad and into the PC400C
Series Panel PC.Step 0:
3.10.5 Stand Mounting
To mount the PC400C Series Panel PC using the stand mounting kit, please follow the
steps below.
Step 1: Locate the screw holes on the rear of the PC400C Series Panel PC. This is
where the bracket will be attached.
Figure 3-18: Stand Mounting Retention Screw Holes
Step 2: Align the bracket with the screw holes.
Step 3: To secure the bracket to the PC400C Series Panel PC, insert the retention
screws into the screw holes and tighten them.Step 0: