User Manual

1010-1023, Rev 00 Page 34
Figure 3-12: Secure the Chassis
3.10.2 Panel Mounting
To mount the PC400C Series Panel PC into a panel, please follow the steps below.
NOTE:
The maximum panel thickness should be no more than 6 mm.
Step 1: Select the position on the panel to mount the PC400C Series Panel PC.
Step 2: Cut out a section of the panel that corresponds to the rear panel dimensions of
the PC400C Series Panel PC. The recommended cutout sizes are shown below
(565HFigure 3-13, 566HFigure 3-14 and 5 67HFigure 3-15).