User Manual

Page 25 1010-1023, Rev 00
Figure 3-1: COM1 to COM5 Pin 9 Setting Jumper Locations
3.6.4 COM5 RS-232/422/485 Serial Port Selection Jumper
Jumper Label:
JP2
Jumper Type:
4-pin header
Jumper Settings:
See Table 3-4
Jumper Location:
See Figure 3-2
The COM5 RS-232/422/485 Serial Port Selection jumper sets the communication protocol
used by the COM5 serial communications port as RS-232, RS-422 or RS-485. The COM5
RS-232/422/485 Serial Port Selection settings are shown in 555 HTable 3-4.
COM5 Mode
Pin 1-2
Pin 3-4
RS-232 (Default)
Short
Open
RS-422
Short
Short
RS-485 (Default: RX)
Open
Short