User Manual

MAPware-7000 Programming Manual 69
1010-1040, Rev. 02
c. Logged Data  uploads any data collected using the Data Logger feature (see
Chapter 8 – Data Logger and Trending -7000
ls).
d. Historical Alarm Data  uploads any alarm messages collected when using the
Historical Alarm feature (see Chapter 7– Alarms 

7. Click the Upload button:
C
Click OK.
8. When the upload is finished, click Close.
Downloading a project
1. Start the MAPware-7000 configuration software and open the project you wish to
download to the unit.
2. Connect to the HMC7000 using either a USB or RS232 serial download cable.
3. Apply power to the unit.
4. Click Project...Tr
5. Under Mode, select Serial or USB connection.
6. Under Download Options (click the Options button if you do not see this
section), select what data you wish to download:
a. Firmware - the internal program inside the HMC7000 that makes it run. If you
are downloading:
i. to a new unit
ii. upgrading the firmware of the unit to a newer version
iii. a project that was created in an older version of MAPware-7000