User Manual

68 MAPware-7000 Programming Manual
1010-1040, Rev. 02
You can now open the MAPware-7000 configuration software and upload/download projects to
the HMC7000 products using a USB connection.
Download/Uploading Projects
Chapter 3 – A Quick Start gives you a step-by-step introduction into creating and downloading a
new project. This section guides you through the specific steps and options of
uploading/downloading a project into your HMC7000 unit.
There are two methods to transfer projects:
 Using MAPware-7000 provides the option of uploading/downloading a project- the
method that we discuss in this section.
 If a computer with MAPware-7000 is not readily available, you can also transfer a file
using the USB Host port with a Flash drive connected to the HMC7000. For more
information on how to do this, see The HMC7000 Series Installation Guide.
Uploading a project
1. Start the MAPware-7000 configuration software. It is not necessary to open a project.
2. Connect to the HMC7000 using either a USB or RS232 serial download cable.
3. Apply power to the unit.
4. 
5. Under Mode, select Serial or USB connection.
6. Under Upload Options (click the Options button if you do not see this
section), select what data you wish to upload:
a. Application  uploads application only (this is the project that you would create
using MAPware-7000)
b. Application + Ladder  uploads the application and the ladder logic. The ladder
logic is any ladder instructions created using the Logic Blocks.