User Manual

40 MAPware-7000 Programming Manual
1010-1040, Rev. 02
 Subtract Tag B from Tag A  when pressed, this button will
1. read the current value in Tag B
2. read the current value in Tag A
3. subtract the Tag B value from the Tag A value
4. write the resulting difference to Tag A
o Alarm Action Buttons  buttons used to control active alarms
 Alarm Acknowledge  creates a button that, when pressed

the plant floor operator
 Acknowledge All  when pressed, this button will acknowledge all active
alarms
 Next Alarm  when pressed, displays the next active alarm (according to
chronological order) in sequence
 Previous Alarm  displays the prior active alarm (according to
chronological order)
o Recipe  these are buttons that control recipes
 Transfer Recipe  when pressed, this button copies a block of internal
memory registers in the HMC7000 to a set of PLC registers or internal
memory registers
 Upload Recipe - when pressed, this button copies a predefined block of
registers in the PLC to a set of internal memory registers in the
HMC7000
o Multi-task Single-state Button  this button is very similar to the Bit Action
Buttons described above except that instead of controlling a single bit/coil, the
Multi-task Single-state button performs one or more tasks. This button
performs the same set of tasks every time the button is pressed and/or
released.
o Multi-task Multi-state Button  this button is similar to the Word Action buttons
above, except that instead of writing to a single register, the Multi-task Multi-
state button performs one or more tasks. In addition, unlike the Multi-task
Single-
that every time the button is pressed, a different set of tasks can be initiated.
 Input Objects  keypads and data entry objects
o Data Entry - objects that display a keypad to change the value of a bit or register
 Bit Entry  this object is very similar to a Toggle Bit object but instead of
writing immediately to the targeted bit whenever the button is pressed,
this object displays a popup keypad. The popup keypad allows you to

bit.
 Numeric Entry  this object displays the current value in a register.
When pressed, a popup keypad appears that allows the operator to
write a new value to the register.
o Keypad  displays a ten-key keypad on the screen
o ASCII Keypad  displays an alphanumeric keypad on the screen
o Custom Keypad  displays a keypad on the screen but without any defined keys.
Programmer defines each key as to operation.
 Display Objects  these are objects that display data stored in a bit or register as a
number or as some graphic representation (i.e. lamp, bar graph, etc.).