User Manual

152 MAPware-7000 Programming Manual
1010-1040, Rev. 02
Register Value Display Data Properties Options
 Color Animation (see Feature List A)  dynamically change the color of the object.
 Flash Animation (List B)  
 Visibility Animation (List C)  
 Background Color (List F)  
 Border (List G)  add a line around the perimeter of the object.
 Flash (List D)  
 Font  select from one of four options- 5x7, 7x14, 10x14, and 20x28 pixels.
 Format  select optional decimal point display and total number of digits to show.
o Digits after Decimal Point- used to display the value in the target register with a
decimal point. Maximum of 10 digits.
o Number of Digits- represents the total number of digits before and after the
decimal point (if used). Maximum of 10 digits.
 Text Color (List Kb)  Determines the color of the text. Click to display the color
palette.
 Design (List S)  identifies object.
 Display Data Properties  Address of target and special features.
o Byte Order  determines how HMC interprets the order of data (word order)
when Data Type is ASCII or ASCII Numeric.
o Data Type  options are:
Data Type
Range
Target Address
(2 bytes)
Target Address
(4 bytes)
Unsigned
0 to 65535
0 to 4294967295
Signed
-32768 to 32767
-2147483648 to
2147483647
Hexadecimal
0000 to FFFF
0000 to FFFFFFFF
BCD
1
0 to 9999
0 to 99999999
Binary
16 bits
16 bits
Floating Point
2
NA
Maximum of 9 digits
ASCII
3
Max length is 255
chars
Max length is 255
chars
ASCII Numeric
4
Max length is 10
chars
Max length is 10
chars
1- If the value in the monitored t
displayed.
2- Floating Point format is based upon the IEEE 754 standard for 32-bit single precision
numbers. A maximum of nine digits is supported. Values are rounded to the nearest decimal
point (ex: if Format: Digits After Decimal Point is set to 1 digit, then floating point number
1.52 would be displayed as 1.5 and 1.56 would be displayed as 1.6).
3- ASCII format interprets the data value in each 16-bit register as two ASCII printable
characters. Hex values 0-9 are displayed as numbers 0-9, 0A-1F is displayed as small case
decimal numbers, 20-FF is printable ASCII characters. The HMC reads consecutive registers