Owner's manual

Index 1
1010-0101, Rev 00
Index
!
3-Wire RS-485 setting 13
A
ASCII Table 40
B
Baud Rate
Baud Rate setting 6
Set Communications Parameters control command 31
Block Echo
Block Echo setting 12
Display Format control command 30
Block Mode 19
Disable Block Mode control command 33
Enable Block Mode control command 33
Keyboard Input Buffer 19
Set Operating Mode control command 31
C
Command Terminator
in Control Commands 28
in Network Mode 20
Configuration 4
3-Wire RS-485 setting 13
Append Linefeed setting 11
Baud Rate setting 6
Block Echo setting 12
Cursor Type setting 15
Data Bits setting 7
Delayed Linefeed setting 13
Display Viewing Angle setting 6
Handshaking setting 8
Key Click setting 16
Line Terminator setting 10
Local Echo setting 11
Local Keyboard setting 16
Local Setup setting 17
Network Address setting 14
Operating Mode setting 10
Parity setting 7
Passwords setting 17
Request Configuration Data control command 29
Save Configuration Parameters control command 29
Stop Bits setting 8
Tab Width setting 14
Turn-Around Delay setting 12
Wrap Around setting 15
Configuration Mode 4
Control Codes 36
BEL 36
BS 36
CAN 36
CR 29, 36
ENQ 36
ESC 29
ETX 29
FF 36
HT 36
LF 29, 36
STX 29
VT 36
XOFF 36
XON 36
Control Commands 28
Clear Output Buffer 32
Create Display Variable 34
Disable Block Mode 33
Display and Cursor Format 30
Display Format 30
Display Message 32
Echo Back Text 31
Enable Block Mode 33
Enable Handshaking 31
Keyboard 30
Poll OIT Buffer 32
Read Cursor Position 34
Read Display Variable 33
Request Configuration Data 29
Request Keyboard Buffer Status 33
Retransmit Last Keyboard Buffer 32
Save Configuration Parameters 29
Set Communications Parameters 31
Set Cursor Position 34
Set LCD Viewing Angle 29
Set Line Terminator 31
Set Operating Mode 31
Set Tab Character Width 30
Set Turn-Around Delay 30
Sound Bell 32
Write Display Variable 34
Cursor
Cursor Type setting 15
Display and Cursor Format control command 30
Read Cursor Position control command 34
Set Cursor Position control command 34
D
Data Bits
Data Bits setting 7
Set Communications Parameters control command 31
Display 24
Display Viewing Angle setting 6
Displaying Text from Predefined Messages 27
Displaying Text from the Host Controller 25
Displaying Text from the OIT's Keypad 24
Using a Display Variable 26
Display Variable 26
Create Display Variable control command 34
Read Display Variable control command 33
Write Display Variable control command 34